Motorola g20 - Table 133. +MIPPUSH Parameters

98-08901C68-O 255
AT Commands Reference
Read Command
Test Command
The following table shows the +MIPPUSH parameters.
Example
at+MIPPUSH=1 //Terminal asks the g20 to flush the buffer in socket 1 (was opened using the
+MIPOPEN command)
+MIPPUSH: 0
OK
4.15.2.7 +MIPFLUSH, Flush Data from Buffers
This command causes the g20 to flush (delete) data accumulated in its accumulating buffers.
Set Command
Command Response/Action
+MIPPUSH? MIPPUSH:<socket ID>,<CR><LF>
For all ACTIVE sockets.
Command Response/Action
+MIPPUSH=? MIPPUSH=(1-4)
Table 133. +MIPPUSH Parameters
<Parameter> Description
Socket ID 1,2,3,4 Number of valid socket
Extended err 3 Operation not allowed
Command Response/Action
+MIPFLUSH = <Socket ID> ERROR
or:
+MIPFLUSH: <Socket ID>
OK