Motorola g20 - Sleep Mode

Using the Commands
278 98-08901C68-O
05E7?
05DC?
000Dcarriage return
000Aline feed
5.7 SLEEP MODE
The terminal should activate Sleep mode by sending ATS24=n (n - number of seconds). To disable Sleep mode, send ATS24=0.
Example of g20 Entering Sleep Mode
Terminal-TX: ATS24=n
Terminal-TX: ATxxx
Terminal-Wakeup-In=Inactive //n seconds passed since last command (and other conditions met)
g20-CTS=Inactive //g20 enters Sleep mode
Example of Terminal Wake g20 Sleep Mode
Terminal-Wakeup-In=Active
g20-CTS=Active //g20 exits Sleep mode
Terminal-TX: ATxxx //30 mseconds passed since Terminal-Wakeup-In became active
Example of g20 Wake Terminal Up
g20-CTS=Active //g20 internal event occurred. Incoming call is pending
//g20 exits Sleep mode
g20-Wakeup-Out=Active
g20-TX: RING //T mseconds passed since Terminal-Wakeup-Out became active
(T is defined by ATS102.)
Note
UCS2 coding for ASCII characters (A-Z, 0-9, and so on) is the same as for their ASCII coding, padded with zeros
to make it 16-bits wide.
UCS2 coding for Hebrew characters is from 05D0 (?) to 05EA (?).
Note
The notation of TXD and RXD are from the perspective of the terminal unless otherwise specified.