Motorola g20 - Table 14. D> Commands

AT Commands Reference
54 98-08901C68-O
4.3.3.2 D>, Direct Dialing from Phone Books
This command places a FAX/DATA/VOICE call on the current network by dialing directly from the g20 phone book.
The following table shows a detailed description for the D> commands.
Command Response/Action
ATD><number>[;] VOICE CALL:
1st response - Voice call place begins
OK
2nd response - Voice call connected:
CONNECT
DATA/FAX:
2nd response only - Data/Fax call connected
CONNECT
When MO call fails:
1. Connection Failure - NO CARRIER or BUSY or NO
ANSWER
2. General Failure - ERROR
Note
+CME ERROR: NOT FOUND is returned when no match is found in an existing phone book.
Table 14. D> Commands
Command Detailed Description
D><alpha>[;] Originates a call to a phone number with the
corresponding alphanumeric field <alpha>. The
currently used memory (phone book) is searched for
the entry that begins with the alphanumeric pattern
<alpha>.
D>mem<n>[;] Originates a call to a phone number in memory (phone
book) mem and stored in entry location <n>. Available
memories may be queried with Select Phone Book
Storage Test command +CPBS=?, described on page
94.
Note: This command does not change the used
memory set.
D><n>[;] Originates a call to a phone number from entry
location <n> in the currently used memory.