Motorola g20 - Table 19. +CLIP Parameters

98-08901C68-O 63
AT Commands Reference
The following table shows the +CLIP parameters.
Example
at+clip?
+CLIP: 0,1
OK
at+clip=1
OK
Table 19. +CLIP Parameters
<Parameter> Description
<n> Enables/disables the CLI presentation indication after the
ring indication:
0 Disable CLI presentation
1 Enable CLI presentation
The default is 0.
<m> Shows the subscriber CLIP service status in the network:
0 CLIP not provisioned
1 CLIP provisioned
2 Unknown (for example, no network and so on)
<"number"> Calling line number. The number format is specified by
<type>.
<type> Type of address octet in integer format:
145 Default when the dialing string includes the
international access code character "+".
129 Default when "+" is not used in the dialing string. The
type of number format is "unknown" - no
international access code is used.
128 Type of number is unknown (usually the output when
the number itself is unknown).
<subaddr> NULL, field not used (String type subaddress of format
specified by <satype>)
<satype> Field not used. Value is always 128 (unknown) - type of sub
address octet in integer format.
<"alpha"> Name of the calling party (if provided by the network or if
the number is found in the g20 phone books).
<CLI validity> The Validity of the Calling Line Identity presentation:
0 CLI valid.
1 CLI has been withheld by the originator.
2 CLI is not available due to networking problems or
limitations of the originating network.