Motorola g20 - Table 24. +CLIR Parameters

AT Commands Reference
76 98-08901C68-O
Test Command
The Test command returns <n> values supported by the g20.
The following table shows the +CLIR parameters.
Example
at+clir=?
+CLIR: (0,1,2)
OK
at+clir?
+CLIR: 1,4 //g20 setting - enable CLIR, network provision is - Temporary mode presentation
allowed
at+clir=2
OK
atd054565195; //MO voice call
OK
(… calling …)
Command Response/Action
+CLIR=? +CLIR: (0,1,2)
Table 24. +CLIR Parameters
<Parameter> Description
<n> Adjustment for outgoing calls
0 Presentation indicator is used according to the
subscription of the CLIR service in the network.
1 Enable (CLIR On = CLI Restricted)
2 Disable (CLIR Off = CLI Presented)
The default is 0.
Note: When <n> is set to 0, the g20 treats CLIR as enabled
if the <m> value is 1 or 3. If the <m> value is 0, 4 or 2, the
g20 treats CLIR as disabled.
<m> Subscriber CLIR service status in the network
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 Unknown (for example, no network and so on)
3 CLIR Temporary mode presentation restricted (can be
the default)
4 CLIR Temporary mode presentation allowed (can be
the default)