Motorola g20 - Table 26. +COLP Parameters

98-08901C68-O 81
AT Commands Reference
In MODE 14, the output of +COLP command must be in one of the following formats: either the name string is not supported,
or there are four commas before the name string, as in the CLIP format.
When enabled (and the called subscriber allows), +COLP: <number>,<type>[,<subaddr>,<satype> [,<alpha>]] intermediate
result code is returned from the TA to the terminal before any +CR or V.25ter responses.
Set Command
The Set command changes the current settings.
Read Command
The Read command gives the result code presentation and COLP service status settings.
Test Command
The Test command returns the values supported by the TA as a compound value.
The following table shows the +COLP parameters.
Note
This command in the current phase is not fully tested, and is subject to change.
Command Response/Action
AT+COLP=[<n>] OK
or:
+CME ERROR: <err>
Command Response/Action
AT+COLP? +COLP: <n>,<m>
OK
Command Response/Action
AT+COLP=? +COLP: (list of supported <n>s)
OK
Table 26. +COLP Parameters
<Parameter> Description
<n> Sets/shows the result code presentation status in the TA
0 Disable
1 Enable
The default value is 0.