Motorola g20 - Table 28. +CPAS Parameters

98-08901C68-O 85
AT Commands Reference
The following table shows the +CPAS parameters
Example
at+CPAS
+CPAS: 000
OK
at+CPAS=?
+CPAS: (000-005)
OK
at+CPAS?
ERROR
AT+CPAS //Voice call active state
+CPAS: 004
OK
Table 28. +CPAS Parameters
<Parameter> Description
<pas> 0 Ready The g20 allows commands from
the terminal
1 Unavailable The g20 does not allow
commands from the TA/TE
2 Unknown The g20 is not guaranteed to
respond to instructions
3 Ringing (MT calls) The g20 is ready for commands
from the TA/TE, but the ringer is
active
4 Call in progress The g20 is ready for commands
from the TA/TE, but a call is in
progress
5 Asleep The g20 is unable to process
commands from the TA/TE as it
is in a low functionality state
Note
g18 backward compatibility <pas> supports values 0,3,4.