3EN At a glance
tablets
Note: For tablets, either insert can be used. If you want
to use the dock for both a tablet and smartphone, use
the pre-installed insert.
Note: The pop-out panel is NOT intended to adjust tilt.
Note: The red alignment mark does not light.
1
Using a protective carrying case?
If so, remove pre-installed adapter.
2
If you don’t have a protective case,
you can replace the pre-installed
adapter with a special tablet
adapter (the one with the smaller
slot in the center).
3
Loosen lock until panel
“pops” out.
Align connectors and connect your
tablet to the dock.
4
5
Tighten the lock.
Note: Tablet must not lean back
freely when tightening the lock.
To Next Page
Loading...
