PREPARING FOR FIELD LEVEL TESTING: Install Flip Assembly
56 68P80401P05
7.15 Install Flip Assembly
7.15.1 Procedure to install flip assembly:
Tools: Black stick.
NOTE: Ensure the flip and housing pivot points are clean.
1. Insert the Hinge Assembly Mechanism into flip right knuckle. Gently press inward until seated
and ensure that the two surfaces are flush.
2. Carefully guide the flex connector through access slot in front housing.
3. Align flip assembly to front housing to resemble a semi closed position.
4. Slip the left knuckle side of the flip into position on the front housing.
5. Slip the right knuckle into the front housing.
Figure 7-10.
2
4
To Next Page
Loading...
