Motorola iDEN i580 - J400 (80 Pin Board-To Flex Connector); M002 (SIMM Connector); M105

MECHANICAL PARTS REWORK AND REPAIR: Mechanical Parts Rework Procedure
82 68P80401P05
9.5.7 J400 (80 Pin Board-to Flex Connector)
NOTE: Use Flux Pen Indium-Indalloy NC771 ONLY (Motorola P/N 1185768C01).
Use flux sparingly
9.5.8 M002 (SIMM Connector)
9.5.9 M105 (Battery Contact
Top 330ºC - Bottom 100ºC N-P32
OK Industries 151/min
Pace 6/7
“L” over J400 during Installation Procedure.
Top 330ºC - Bottom 100ºC N-P32
OK Industries 201/min
Pace 8/9
“L” over M002 & J401 during Installation
Procedure.
Top 330ºC - Bottom 100ºC N-P20
OK Industries 151/min
Pace 6/7
“F” over J600 during Removal Procedure.
“F” over J600 & F over M105 during Installation
Procedure.