19
English
English
Note: Not all screens shown will be displayed. For
example, Waiting to Charge displays (battery hot,
cold, low voltage) will only be shown if the situation
warrants.
Note: Fully charged IMPRES batteries immedi-
ately inserted into a different pocket will show a
slightly lower initial capacity due to stand loss esti-
mation, but the charger will correct this deviation
when the battery reaches full charge in the new
pocket, typically in a few minutes.
Note:
(1) Estimated time to complete charging includes
trickle charge and discharge cycles (if applica-
ble).
(2) Battery capacity information is not displayed for
uncalibrated batteries.
(3) Use of IMPRES batteries with non-IMPRES
chargers can affect capacity and charging time
accuracy.
(4) Fully charged IMPRES NiCd & NiMH batteries
inserted into a pocket will initially show 1 hour
and 10 minutes estimated time to complete
charge, but will typically revert to solid GREEN
within a few minutes.
Estimated Time to Charge
Complete Displayed in Hours, Minutes (NiCd &
NiMH only)
LED Defined by Charge State
Line 1 EST COMPLETE IN
Line 2 --HRS, --MIN
CDM_Install - B.fm Page 19 Monday, February 10, 2003 2:51 PM
To Next Page
Loading...
