Doc Title : Product Data – User’s Guide Revision : R.00
Model : L401 series & L301 series Page(s) : 7 of 38
This document contains confidential and proprietary information of VTech Telecommunications Ltd
Install and charge the handset battery pack
1. Slide out the battery compartment cover.
2. Place the supplied rechargeable battery pack in the battery compartment.
3. Slide the battery compartment cover back.
4. Put the handset on the base to charge for at least 24 hours. When the handset is fully charged the <Battery
icon> will indicate that it is fully charged.
5. Use only the rechargeable battery pack provided.
BATTERY LOW WARNING
If the <Battery icon> flashes in the display, you will need to recharge the handset before you can use it again.
During charging, the <Battery icon> will scroll in the display.
BATTERY PERFORMANCE
In ideal conditions, fully charged battery pack should give about 12 hours talk time or 180 hours standby time on a
single charge.
Note that new battery packs do not reach full capacity until they have been in normal use for several days.
To keep your battery packs in the best condition, leave the handset off the base for a few hours at a time.
Running the battery packs right down at least once a week will help them last as long as possible.
The charge capacity of rechargeable battery packs will reduce with time as they wear out, giving the handset less
talk/standby time. Eventually they will need to be replaced.
After charging your handset for the first time, subsequent charging time is about 6–8 hours a day. The battery pack
and handset may become warm during charging. This is normal.
To Next Page
Loading...
Need help?
General
