EasyManua.ls Logo

Motorola L601 - Getting Started; Connecting the Base Unit

Motorola L601
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Doc Title : Product Data - User Manual Revision : R.00
Model : Motorola L601 series & L701 series Page(s) : 6 of 30
This document contains confidential and proprietary information of VTech Telecommunications Ltd
1.
Getting Started
WARNING
Do not place your phone in the bathroom or other humid areas.
Location
When choosing a location for your new phone, here are some important guidelines you should consider:
Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, heating appliances and
direct sunlight.
Avoid areas of excessive dust, moisture and low temperature.
Avoid other cordless telephones or personal computers.
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Never touch non-insulated telephone wires or terminals, unless the telephone line has been disconnected at the
network interface.
Use caution when installing or modifying telephone lines.
HANDSET RANGE
Optimal range is reached when there are no other electrical appliances working within the range area. Any
obstruction between the base and handset will also reduce the range significantly.
SIGNAL STRENGTH
When out of range of the corded base, the screen shows OUT OF RANGE. If you are on a call, the line will hang
up. Move back within in range. The cordless handset will automatically re-connect to the corded base.
Setting up
IMPORTANT
The base must be plugged into an electrical outlet at all times. Do not connect the telephone line cord into the
telephone wall jack until the handset is fully charged. Only use the adapter and telephone line cord supplied with
the product.
WHICH POWER ADAPTER?
The power adapter with the red crystal is for the base unit and the power adapter with the larger pin is for the
charger unit (only for multi-handset packs).
.1 Connecting the base
For L601 series:

Table of Contents

Related product manuals