configuration, post-loaded applications and user passwords. After reset is performed, re-enter your backed up
information.
When and where to use: Use this procedure to perform factory data reset:
Caution: Factory data reset is performed only by technical support as a last resort when the LEX L10 fails
to operate. Before performing factory data reset, remove the SIM and microSD cards from the LEX L10.
Performing factory data reset with a microSD or SIM cards installed may cause data corruption or loss.
Note: Factory data reset configures the LEX L10 to public communication only. To return to combined
Public and Private configuration, see your technical support. The last updated firmware and the initial
version of pre-loaded applications are preserved through a reset to factory defaults.
Procedure:
1
Tap .
2
Tap .
3 Tap Backup & reset.
4 Tap Factory data reset.
The LEX L10 powers off, powers on, then the system recovery screen appears.
Maintenance & Troubleshooting | 153
MN001456A01-A | February 2015 | Send Feedback
To Next Page
Loading...
