4 - 14 LI4278 Product Reference Guide
Reconnect Attempt Beep Feedback
When a linear imager scanner disconnects as it goes out of range, it immediately attempts to reconnect. While
the linear imager scanner attempts to reconnect, the green LED continues to blink. If the auto-reconnect
process fails, the linear imager scanner emits a page timeout beep (long low/long high) and stops blinking the
LED. The process can be restarted by pulling the trigger.
The Beep on Reconnect Attempt feature is disabled by default. When enabled, the linear imager scanner emits
5 short high beeps every 5 seconds while the reconnection attempt is in progress.Scan a bar code below to
enable or disable Beep on Reconnect Attempt.
*Disable Beep on Reconnect Attempt
Enable Beep on Reconnect Attempt
To Next Page
Loading...
