RADIO COMMUNICATIONS 4 - 15
Reconnect Attempt Interval
When a linear imager scanner disconnects as it goes out of range, it immediately attempts to reconnect for the
default time interval of 30 seconds. This time interval can be changed to one of the options below.
To set the Reconnect Attempt Interval, scan one of the bar codes below.
*Attempt to Reconnect for 30 Seconds
Attempt to Reconnect for 1 Minute
Attempt to Reconnect for 5 Minutes
Attempt to Reconnect for 30 Minutes
Attempt to Reconnect for 1 Hour
Attempt to Reconnect Indefinitely
To Next Page
Loading...
