Symbologies 12 - 11
User-Programmable Supplementals
If you selected a Supplemental User-Programmable option from Decode UPC/EAN/JAN Supplementals on page
12-8, select User-Programmable Supplemental 1 to set the 3-digit prefix. Then select the 3 digits using the
numeric bar codes beginning on page D-1. Select User-Programmable Supplemental 2 to set a second 3-digit
prefix. Then select the 3 digits using the numeric bar codes beginning on page D-1.
User-Programmable Supplemental
1
User-Programmable Supplemental 2
UPC/EAN/JAN Supplemental Redundancy
With Autodiscriminate UPC/EAN/JAN Supplementals selected, this option adjusts the number of times a
symbol without supplementals is decoded before transmission. The range is from two to thirty times. 14 or above is
recommended when decoding a mix of UPC/EAN symbols with and without supplementals. The default is 14.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes from Appendix D,
Numeric Bar Codes. Enter a leading zero for single digit numbers. In case of an error, or to change the selection,
scan Cancel on page D-3.
UPC/EAN/JAN Supplemental Redundancy
To Next Page
Loading...
