13 - 8 Symbol LS3408 Product Reference Guide
Synapse Interface
The auto-detection of a Synapse cable must vary in duration depending on the type of Synapse connection. If a
scanner is connected to another scanner using a Synapse cable, select Auxiliary Synapse Port Connection. In
all other cases when using the cable, Motorola recommends the default setting.
To disconnect and reconnect the scanner from a Synapse cable that is connected to a live host, select “Plug and
Play” Synapse Connection. Do not change this setting from the default if an on-board wedge host is enabled.
*Standard Synapse Connection
Auxiliary Synapse Port Connection
“Plug and Play” Synapse Connection
To Next Page
Loading...
