4 - 2 Symbol LS3408 Product Reference Guide
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences Default Parameters
Table 4-1 lists the defaults for user preferences parameters. To change any option, scan the appropriate bar
code(s) provided in the User Preferences section beginning on page 4-3.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 4-1
User Preferences Default Table
Parameter Default
Page
Number
User Preferences
Set Default Parameter Restore Defaults
4-3
Parameter Scanning Enable
4-4
Beeper Tone High
4-4
Beeper Volume High
4-5
Power Mode Continuous On
4-5
Laser On Time 3.0 sec
4-6
Beep After Good Decode Enable
4-6
Trigger Mode Level
4-7
Aim Duration 0.0 sec
4-8
To Next Page
Loading...
