10 Getting Started
2. Getting Started
2.1 Baby Unit Power Supply
1. Connect the small plug of the Power Adapter to the Baby Unit (Camera)
and the other end to the electrical outlet.
NOTE
Only use the enclosed Power Adapter (6V DC / 500mA) with the slightly larger
DC plug.
2. Slide the ON/OFF switch to the ON position. The power LED will light up
in orange.
3. Slide the ON/OFF switch to the OFF position to turn the Baby Unit off.
2.2 Parent Unit Battery Installation
The supplied rechargeable battery pack should be fitted so that the Parent Unit
can be moved without losing the link with the Camera. Charge the battery in the
Parent Unit before first time use or when the Parent Unit indicates that the
battery is low.
1. Insert the plug of the rechargeable battery pack into the small socket inside
the battery compartment as shown above and fit the battery pack into the
compartment.
To Next Page
Loading...
