11
ENGLISH
Getting Started
1. Connect the plug of the power adapter to the Parent Unit and the other
end to a suitable mains power socket. Only use the enclosed power
adapter (5V DC / 1000mA).
2. Press and hold the
0
POWER ON/OFF button for 3 seconds to turn ON
the Parent Unit.
3. Once the Baby and Parent Units are switched on, the display on the
Parent Unit will show the video captured by the Baby Unit.
4. If there is no connection or you are out of range, the unit will beep
every few seconds. Move the Parent Unit closer to the Baby Unit until
the link is re-established.
5. Press and hold the
0
POWER ON/OFF button, until the progress bar
finishes scrolling, to turn OFF the Parent Unit.
NOTE
The battery icon turns RED to indicate that the battery is low,
and the parent unit will beep about every 15 seconds. The battery
needs to be recharged; it will take 16 hours to charge fully.
When charging
1. If the Parent Unit is turned OFF with the adapter plugged in, a 2-pin
plug logo will appear on-screen for about 5 seconds, and then a flashing
battery logo will display for 15 seconds. The Blue LED at the top left
will light up; indicating that the adapter is plugged in and charging is
continuing.
2. Whilst the power is ON, and the adapter is plugged in, the battery
icon at the top right corner of the screen will show that the battery
is charging. The Blue LED at the top left will light up to indicate
that the adapter is plugged in.
To Next Page
Loading...
