Motorola MD1600 - Page 102

User Manual
98
 RA
DIUS Server IP Address: Enter the IP address of the RADIUS server.
RADIUS server is used to authenticate the hosts on the wireless network.
 RADIUS Port: The port number that the RADIUS server uses. The default
port number is 1812. You may change it according to the server setting.
 RADIUS Key: Set the RADIUS key for accessing the RADIUS server.
 WEP Encryption: You can only select Enabled.
 Encryption Strength: You can set 64-bit or 128-bit key.
 Current Network Key: The current key that you use.
 Network Key1/2/3/4: Set the network key. If it is 128-bit key, you need to
enter 13 ASCII characters or 26 hexadecimal digits. For the 64-bit key, you
need to enter 5 ASCII characters or 10 hexadecimal digits.
-
WP
A Mode
 Se
lect SSID: Select a SSID for configuring the security settings.
 Network Authentication: Select the WPA-PSK mode.
 WPA Group Rekey Interval: Setting the interval for renewing key.
 RADIUS Server IP Address: Enter the IP address of the RADIUS server.
RADIUS server is used to authenticate the hosts on the wireless network.
 RADIUS Port: The port number that the RADIUS server uses. The default
port number is 1812. You may change it according to the server setting.
 RADIUS Key: Set the RADIUS key for accessing the RADIUS server.
 WPA/WAPI Encryption: You may select AES, or TKIP+AES.