Setting up times when Internet access is allowed and
not allowed
You can allow Internet access for a particular device only during hours
that you specify. Access will be allowed to all Internet sites. Internet
access will not be allowed to any site outside of the hours that you
specify.
To do this, enter a Policy Name (e.g. Ann’s Laptop). Make sure the
device you want to control is powered on and connected to the
MG8702. Use the Select Device pulldown to select this device. The
pulldown will show the MAC Addresses of devices connected to your
MG8702. You may find the MAC Address of the device you want to
control from the device itself. Follow instructions for the device and
operating system to do this.
You may also find the device’s MAC Address by looking at the client list
on your MG8702. Click Basic Router DHCP and look at the MAC
Addresses in the DHCP Client List:
You may have to do a little sleuthing to find your device’s MAC Address,
for example by turning the device off and on again to see which MAC
Address is removed and then restored to the list.
To Next Page
Loading...
