Pager Programming Software (PPS)
English
22
Priority Tone Alert
This feature allows you to override the
vibrate settings of the Function Switch for
Call Address 1 on Frequency 1 to always
sound a tone alert instead.
There are two options available.
• On: The pager sounds a tone alert
instead of vibrating to indicate an
incoming message — even when the
alert type is set as vibrate.
• Off: The pager vibrates to indicate an
incoming message — when the alert type
is set as vibrate.
Privacy
This feature allows you to disable the ability
to monitor the channel when you press and
hold the Reset button — unless Push-To-
Listen is enabled for silent scan or selective
call modes.
There are two options available.
• On: Pressing and holding the Reset
button does not place the pager in
monitor mode.
• Off: Pressing and holding the Reset
button places the pager in monitor mode.
6800969001_EN.book Page 22 Monday, January 13, 2014 11:40 AM
To Next Page
Loading...
