Pager Programming Software (PPS)
English
24
generates a page alert and stores the
message.
Note: The page alert may be an audible or a
vibrate — depending on the Function Switch
position.
• In Selective Call mode, the audio will
remain turned off until a page is
received, where upon your pager will
alert, indicating the carrier squelch
operation is enabled. The pager will
then turn the audio off according to the
current Reset mode.
• Additional programmable options are
Off Duty, Priority Tone Alert, Push-To-
Listen, and Privacy mode.
Note: Selective Call can be set for up to five
different frequencies, labeled as F1, F2, F3,
F4, and F5.
• Monitor:
• This mode allows you to monitor
activity on a programmed frequency
(carrier squelch operation).
• Only one frequency can be monitored
at a time. When a page is detected, the
pager generates a page alert and
stores the message.
Note: Monitor can be set for up to 5 different
frequencies, labeled as F1, F2, F3, F4, and
F5.
• Probability Scan:
• This mode allows you to monitor traffic
on two different frequencies.
• The pager monitors any activity on
both frequencies. If activity is detected
on either frequency, the receiver will
lock on to that frequency until the
transmission ends.
6800969001_EN.book Page 24 Monday, January 13, 2014 11:40 AM
To Next Page
Loading...
