Pager Programming Software (PPS)
English
26
Note: Neither frequency will have
monitoring precedence over the other.
• The receiver alternately scans the two
frequencies and the audio remains
turned off. When a page is detected,
the pager generates a page alert and
performs message storage.
• Upon receiving a page, the audio will
turn on immediately after the page alert
(enabling the carrier squelch
operation). The pager will then turn the
audio off according to the current
Reset mode. The receiver will then
resume the silent scan activity.
• Disabled:
• This mode allows you to disable a
Function Switch position. When
programmed, the pager will play a low
frequency tone when switching the
channel knob to this position.
Alert Type
This option allows you to set the type of
alerts to be activated when the pager is
powered up or when there is an incoming
page.
There are three different alert types
available.
• Tone: The pager plays a tone.
• Vibrate: The pager vibrates.
• Tone & Vibrate: The pager plays a tone
and vibrates simultaneously.
Note: While the pager is in the Amplifier
Charger it will not alert if it is set to vibrate.
6800969001_EN.book Page 26 Monday, January 13, 2014 11:40 AM
To Next Page
Loading...
