The display shows Call Ended.
See Making a Private Call on page 176 for details on
making a Private Call.
Receiving a Site All Call
A Site All Call is a call from an individual radio to
every radio on the site. It is used to make important
announcements requiring the user’s full attention.
When you receive an Site All Call, a tone sounds and
the LED blinks green.
The first line of the display shows the RSSI icon. The
second line displays the Site All Call icon.The third
line displays Site All Call. The fourth line displays
the Caller Alias. Your radio unmutes and the
incoming call sounds through the radio speaker.
Once the Site All Call ends, the radio returns to the
previous screen before receiving the call. A Site All
Call does not wait for a predetermined period of time
before ending.
You cannot respond to an Site All Call.
Note: See Making a Site All Call on page 177 for
details on making a Site All Call.
Note: The radio stops receiving the Site All Call if you
switch to a different channel while receiving the call.
During a Site All Call, you will not be able to use any
programmed button functions until the call ends.
Receiving an Inbound Private Phone Call
When you receive an Inbound Private Phone Call, the
Phone Call as Private Call icon appears in the top
right corner. The first text line shows Phone Call.
1 Press and hold down PTT button to answer and
talk. Release the PTT button to listen.
2
Long press to end the call.
The first line of the display shows Ending. The
second line of the display shows Phone Call....
The display returns to the Phone Call screen.
The display shows Phone Call Ended.
Making a Buffered Over-Dial in an Inbound Phone
Private Call
During the call, the Phone Call as Private Call icon
appears in the top right corner. The first text line of
the display shows Phone Call.
Making and Receiving Calls in Connect Plus Mode
173
English
To Next Page
Loading...