If there is no voice activity for a predetermined
period of time, the call ends. Radio returns to the
screen you were on prior to initiating the call.
Making a Private Call
While you can receive and/or respond to a Private
Call initiated by an authorized individual radio, your
radio must be programmed for you to initiate a Private
Call.
You will hear a negative indicator tone, when you
make a Private Call via the Contacts list, Call Log,
One Touch Access button, if this feature is not
enabled.
Use the Text Message or Call Alert features to
contact an individual radio. See Text Message
Features on page 206 or Call Alert Operation on
page 88 for more information.
1 Do one of the following.
• Select the channel with the active subscriber
alias or ID. See Selecting a Call Type on page
171.
• Press the programmed One Touch Access
button.
2 Hold the radio vertically 1 to 2 inches (2.5 to 5.0
cm) from your mouth.
3 Press the PTT button to make the call.
If you release the PTT button while the radio is
setting up the call, it exits without any indication
and returns to the previous screen.
The LED lights up solid green, the radio unmutes
and the response sounds through the radio’s
speaker. The Private Call icon appears on the top
right corner. The first text line shows the target
subscriber alias. The second text line displays the
call status.
4 Wait for the Talk Permit Tone to finish (if enabled),
and speak clearly into the microphone.
5 Release the PTT button to listen.
When the target radio responds, the LED blinks
green, the radio unmutes and the response
sounds through the radio's speaker.
If there is no voice activity for a predetermined
period of time, the call ends. You hear a short
tone. The display shows Call Ended.
Making and Receiving Calls in Connect Plus Mode
176
English
To Next Page
Loading...