If there is no check mark preceding the Group
name, then scan is currently disabled for this
Group.
4
to select the desired Group.
The display shows Enable if scan is currently
disabled for the Group.
The display shows Disable if scan is currently
enabled for the Group.
5
Select the displayed option (Enable or Disable)
and press to select.
Depending on which option was selected, the
radio momentarily displays Scan Enabled or Scan
Disabled as confirmation.
The radio displays the Zone scan list again. If scan
was enabled for the Group, the check mark displays
before the Group name. If scan was disabled for the
Group, the check mark is removed before the Group
name.
Add or Delete a Group via the Add Members
Menu
The Connect Plus radio does not allow a duplicate
group number or a duplicate group alias to be placed
on a zone scan list (or to be shown as a “scan
candidate”). Thus, the list of “scan candidates”
described in steps 6 and 7 sometimes changes after
adding or deleting a group from the zone scan list.
If your radio has been programmed to allow you to
edit the scan list, you can use the Add Members
menu to add a group to the scan list of the currently
selected zone, or to delete a group from the san list of
the currently selected zone.
1
to access the menu.
2
or to Scan option and press to select.
3
or to <Add Members> and press to
select.
The display shows “Add Members from Zone n” (n
= the Connect Plus zone number of the first
Advanced Features in Connect Plus Mode
190
English
To Next Page
Loading...