Radio
Control
Steps
The first line of the display shows
the characters you keyed in. The
next lines of the display show the
short listed search results. The
alias search is case-insensitive. If
there are two or more aliases with
the same name, the radio displays
the alias that is listed first in the list.
5
Press
to select.
6
or to Edit Priority and press to
select.
7
or to the required priority level and press
to select.
The display shows Entry Saved before returning
to the previous screen.
Note: The Priority icon appears left of the
member’s name.
There is no Priority icon if priority is set to None.
Scan
When you start a scan, your radio cycles through the
programmed scan list for the current channel looking
for voice activity.
The LED blinks yellow and you see the Scan icon on
the display.
There are two ways of initiating scan:
• Main Channel Scan (Manual): Your radio scans
all the channels/groups in your scan list. On
entering scan, your radio may – depending on the
settings – automatically start on the last scanned
“active” channel/group or on the channel where
scan was initiated.
• Auto Scan (Automatic): Your radio automatically
starts scanning when you select a channel/group
that has Auto Scan enabled.
Note: This feature is not applicable in Capacity Plus
and Linked Capacity Plus.
Advanced Features in Non-Connect Plus Mode
69
English
To Next Page
Loading...