Note: The DTMF tone sounds.
If the entry for the One Touch Access button
is empty, a negative indicator tone sounds.
During the call, when you press One Touch
Access button with the deaccess code
preconfigured or enter the deaccess code as the
input for extra digits, your radio attempts to end
the call.
8
Press to end the call.
9 If deaccess code was not preconfigured in the
Contacts list, the first line of the display shows De-
Access Code:. The second line of the display
shows a blinking cursor. Enter the deaccess code
and press
to proceed.
The deaccess code cannot be more than 10
characters.
The DTMF tone sounds and the display shows
Ending Phone Call.
If successful, a tone sounds and the display shows
Phone Call Ended. Your radio returns to the Call
Phone screen.
If unsuccessful, your radio returns to the Phone
Call screen. Repeat Steps 8 and 9 or wait for the
telephone user to end the call.
When the telephone user ends the call, a tone
sounds and the display shows Phone Call
Ended.
Making a Call Alias Search
You can also use alias or alphanumeric search to
retrieve the required subscriber alias.
This feature is only applicable while in Contacts.
Note: Press
button or to exit alias search.
If you release the PTT button while the radio is setting
up the call, it exits without any indication and returns
to the previous screen.
Your radio may be programmed to perform a radio
presence check prior to setting up the Private Call. If
the target radio is not available, you hear a short tone
and see negative mini notice on the display.
1
to access the menu.
Advanced Features in Non-Connect Plus Mode
76
English
To Next Page
Loading...