Advanced Features
English
60
Setting the Squelch Level
You can adjust your radio's squelch level to filter out unwanted
calls with low signal strength or channels that have a higher
than normal background noise.
Settings: Normal is the default. Tight filters out (unwanted)
calls and/or background noise. However, calls from remote
locations may also be filtered out.
Procedure:
Press the programmed Squelch button to toggle squelch level
between normal and tight.
OR
Follow the procedure below.
1 g to access the menu.
2 b or c to Utilities and press g to select.
3 b or c to Radio Settings and press g to select.
4 b or c to Squelch and press g to select.
5 The display shows Tight and Normal. b or c to the
required setting and press
g to enable. 9 appears
besides selected setting.
6 Screen returns to the previous menu.
Turning the LED Indicators On or Off
You can enable and disable the LED Indicators if needed.
Procedure:
1 g to access the menu.
2 b or c to Utilities and press g to select.
3 b or c to Radio Settings and press g to select.
4 b or c to LED Indicator and press g to select.
5 b or c to On to enable LED Indicator. The display
shows 9 beside On.
OR
b or c to Off to disable LED Indicator. The display
shows 9 beside Off.
To Next Page
Loading...
