3
English
Powering Up the Radio
Rotate the On/Off/Volume Control Knob clockwise until
you hear a click. The LED lights up solid green.
A brief tone sounds, indicating that the power up test is
successful.There is no power up tone if the radio tones/
alerts function is disabled.
If your radio does not power up, check your battery. Make
sure that it is charged and properly attached. If your radio
still does not power up, contact your dealer.
To turn off the radio, rotate this knob counterclockwise until
you hear a click.
Adjusting the Volume
To increase the volume, turn the On/Off Volume Control
Knob clockwise.
To decrease the volume, turn this knob counterclockwise.
NOTE: Your radio can be programmed to have a minimum
volume offset where the volume level cannot be
turned down fully. Check with your dealer or
system administrator for more information.
Accessing the Radio from Password
1. Power up the radio.
2. You hear a continuous tone.
3. Use the Channel Selector Knob to enter the first digit of
the password.
4. Press Side Button 1 or 2 to enter each digit of the
remaining three digits of the password. You hear a
positive indicator tone for each Side Button press.
When the second digit of the password is entered, your
radio ignores any Channel Selector Knob position
change.
5. When the last digit of the four-digit password is entered,
your radio automatically checks the validity of the
password. If the password is correct: Your radio
proceeds to power up. See Powering Up the Radio on
page 3.
OR
If the password is incorrect: You hear a continuous tone.
Repeat Steps 1 to 3.
OR
After the third incorrect password, your radio enters into
locked state. A tone sounds and the LED double blinks
yellow.
Andorra_QRC-APAC_EN.fm Page 3 Tuesday, May 28, 2013 9:41 AM
To Next Page
Loading...