Receiving and Making Calls
English
23
Making a Phone Call with the Programmable
Phone Button
Procedure:
1 Press the programmed Phone button.
2 The LED lights up solid green.
3 You hear the dialing tone of the telephone user.
4 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from
your mouth.
5 Press the PTT button to talk and release it to listen.
6 Press d to end the call.
OR
Press One Touch Access button. If the entry for the One
Touch Access button is empty, a negative indicator tone
sounds.
When you press PTT button while in the Phone Contacts
screen, a tone sounds.
When the telephone user ends the call, a tone sounds.
During channel access, press
d to dismiss the call attempt
and a tone sounds.
During the call, when you press One Touch Access button with
the deaccess code preconfigured, your radio attempts to end
the call.
Stopping a Radio Call
This feature allows you to stop an ongoing Group or Private Call
to free the channel for transmission. For example, when a radio
experiences a “stuck microphone” condition where the PTT
button is inadvertently pressed by the user.
Your radio must be programmed to allow you to use this feature.
Procedure:
While on the required channel:
1 Press the programmed Transmit Interrupt Remote Dekey
button.
2 Wait for acknowledgment.
3 The radio sounds a positive indicator tone, indicating that
the channel is now free.
OR
The radio sounds a negative indicator tone, indicating that
the radio is unable to free the channel.
Your radio sounds a negative indicator tone until you release
the PTT button, if it is transmitting an interruptible call that is
stopped via this feature. On an interrupted radio with a display,
the display shows
Call Interrupted
.
NDP_APAC.book Page 23 Wednesday, July 18, 2012 4:37 PM
To Next Page
Loading...