Advanced Features
English
95
Over-the-Air Programming (OTAP)
Your radio can be updated by your dealer remotely, via OTAP,
without needing to be physically connected. Additionally, some
settings can also be configured via OTAP.
While undergoing OTAP, the LED blinks green.
NOTE: When the radio is receiving high volume data, the High
Volume Data icon appears and channel is busy. A PTT
button press at this time causes a negative tone to
sound.
Once the programming is complete, depending on your radio’s
configuration:
• A tone sounds, the display shows Updating Restarting,
and your radio restarts (powers off and on again).
• Select between Restart Now or Postpone. Selecting
Postpone allows your radio to return to the previous display,
with an OTAP Timer icon visible, for a period of time before
the automatic restart occurs.
Upon power up after the automatic restart occurs, the display
shows Sw Update Completed if the OTAP update is successful
or Sw Update Failed if the OTAP update is unsuccessful.
See Software Update on page 112 for your updated software
version.
Utilities
Turning the Radio Tones/Alerts On or Off
You can enable and disable all radio tones and alerts (except for
the incoming Emergency alert tone) if needed.
Procedure:
Press the programmed All Tones/Alerts button to toggle all
tones on or off.
OR
Follow the procedure below.
1 c to access the menu.
2 ^ or v to Utilities and press c to select.
3 ^ or v to Radio Settings and press c to select.
4 ^ or v to Tones/Alerts and press c to select.
5 ^ or v to All Tones and press c to select.
6 Press c to enable all tones. The display shows 9 beside
Enabled.
OR
Press
c to disable all tones. The 9 disappears from
beside Enabled.
FKP_APAC.book Page 95 Thursday, October 11, 2012 10:42 AM
To Next Page
Loading...