Preparing Your Radio for Use
English
2
NOTE: Specifications may vary for different radio models.
Check with your dealer or system administrator for
more information.
Preparing Your Radio for Use
Assemble your radio by following these steps:
Charging the Battery. . . . . . . . . . . . . . . . . . . . . . . . . . . page 2
Attaching the Battery. . . . . . . . . . . . . . . . . . . . . . . . . . . page 3
Attaching the Antenna. . . . . . . . . . . . . . . . . . . . . . . . . . page 3
Attaching the Belt Clip. . . . . . . . . . . . . . . . . . . . . . . . . . page 4
Attaching the Universal Connector
Cover (Dust Cover) . . . . . . . . . . . . . . . . . . . . . . . . . . page 4
Powering Up the Radio. . . . . . . . . . . . . . . . . . . . . . . . . page 5
Adjusting the Volume . . . . . . . . . . . . . . . . . . . . . . . . . . page 5
Charging the Battery
For best performance, your radio is powered by a
Motorola-approved Lithium-Ion (Li-lon) battery. To avoid
damage and comply with warranty terms, charge the battery
using a Motorola charger exactly as described in the charger
user guide.
If battery is attached to your radio, ensure that your radio
remains powered off while charging.
Charge a new battery 14 to 16 hours before initial use for best
performance.
IMPORTANT: ALWAYS charge your IMPRES battery with an
IMPRES charger for optimized battery life and
valuable battery data. IMPRES batteries
charged exclusively with IMPRES chargers
receive a 6-month capacity warranty extension
over the standard Motorola Premium battery
warranty duration.
Charge your battery only in non-hazardous
areas. After battery is charged, allow your radio
to rest for at least 3 minutes. See Batteries on
page 114 for available batteries.
FKP_APAC.book Page 2 Thursday, October 11, 2012 10:42 AM
To Next Page
Loading...