Motorola Mototrbo - Power-Up Self Test; 1.0 Power-Up Error Codes

4-1
Section 4
POWER-UP SELF TEST
NOTE: This section is for reference only. If at any time one of the error codes is present, the radio
should be returned to a qualified Motorola Service Center.
1.0 Power-Up Error Codes
When the radio is turned on (powered-up), the radio performs cursory tests to determine if its basic
electronics and software are in working order. Problems detected during these tests are presented
as error codes on the radio’s display. The presence of an error should prompt the user that a
problem exists and that a service technician should be contacted.
Self-test errors are classified as either fatal or non-fatal. Fatal errors inhibit user operation; non-fatal
errors do not. Use the following table to aid in understanding particular power-up error code
displays.
Table 4-1 Power-Up Error Codes
Error Code Description Error Type Corrective Action
ERROR 01/02 FLASH ROM Codeplug
Checksum
NON-FATAL Reprogram the codeplug.
ERROR 01/22 Tuning Codeplug
Checksum
NON-FATAL Reprogram the tuning partition.
FAIL 01/82 FLASH ROM Codeplug
Checksum
FATAL Reprogram the codeplug.
FAIL 01/90 General Hardware Error FATAL Turn the radio off, then on. If problem
persists, send radio to the nearest
Motorola Solutions Depot.
FAIL 01/92 Security Partition
Checksum
FATAL Reprogram the security partition.
FAIL 01/93 FlashPORT AUTHENT
CODE Failure
FATAL Contact the depot.
FAIL 01/A2 Tuning Codeplug
Checksum
FATAL Reprogram the tuning partition.
FAIL 02/90 RF Hardware Error FATAL Send radio to the nearest Motorola
Solutions Depot.