Motorola Mototrbo - 11.5.2.9 Back Panel Removal

Procedure:
1 Remove the nut securing the N-Type connector to the back panel on the Power Amplifier with a
¾ inch (19 mm) hex nut driver.
2 Remove the accompanying lock washer.
3 Remove the four screws securing the Power Amplifier Module to the Repeater chassis with a
T20 Torx driver.
Figure 55: Removing Power Amplifier Module
4 Remove the Power Amplifier Module from the Repeater.
11.5.2.9
Back Panel Removal
Procedure:
1 Remove the two nuts securing the RX and Reference (REF) BNC cables to the back panel with
a 16 mm hex nut driver.
2 Remove the two corresponding lock washers.
3 Remove the two cables.
Figure 56: Removing Rx and REF BNC Cables
4 Remove the ground screw located below the REF connector with a T30 Torx driver.
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
Motorola Solutions Confidential
100 Send Feedback