Motorola Mototrbo - Document History

To Next Page

To Previous Page

Document History

The following major changes have been implemented in this manual since the previous edition:

Edition Description Date

MN001436A01-AA Initial Release April 2015

Document History

Motorola Solutions Confidential

Send Feedback 11

Main Page

Foreword3
- General Safety Precautions3
- Computer Software Copyrights3
- Document Copyrights3
- Disclaimer3
- Trademarks4
General Safety and Installation  Standards and Guidelines5
MOTOTRBO SLR 5000 Series Repeater  Supplemental Safety and Installation Requirements7
Environmental Information9
- Material Content9
- Disposal of your Electronic and Electric Equipment9
- Disposal Guideline9
Document History11
Contents13
List of Figures21
List of Tables25
Summary of Bands Available27
Commercial Warranty29
- Limited Warranty29
SLR 5000 Series Repeater33
- 1.1 Notations Used in This Manual33
- 1.2 Description33
- 1.3 Operating Features35
- 1.4 Frequency Ranges and Power Levels37
- 1.5 Specifications37
- 1.6 Theory of Operation39
- 1.7 Basic Repeater Level Troubleshooting – RDAC and LEDs41
- 1.8 Repeater Model Numbering Scheme43
- 1.9 Model Chart43
  - 1.9.1 VHF High Power43
  - 1.9.2 UHF1 High Power44
SLR 5000 Series Satellite Receiver45
- 2.1 Description45
- 2.2 Operating Features45
- 2.3 Frequency Ranges45
- 2.4 Specifications45
- 2.5 Configuration45
- 2.6 Basic Station Level Troubleshooting – RDAC and LEDs46
- 2.7 Model Chart46
SLR 5000 Series Modem47
- 3.1 Description47
- 3.2 Receiver Subsystem49
  - 3.2.1 Description49
  - 3.2.2 Specifications49
- 3.3 Transmitter Exciter Subsystem50
  - 3.3.1 Description50
  - 3.3.2 Specifications50
- 3.4 Station Control Subsystem51
- 3.5 Station Control Interface52
SLR 5000 Series Power Amplifier55
- 4.1 Description55
  - 4.1.1 General Description55
- 4.2 Input and Output Connections55
- 4.3 Frequency Ranges56
- 4.4 Specifications56
- 4.5 Modem Interface57
SLR 5000 Series Power Supply59
- 5.1 Description59
  - 5.1.1 General Description59
- 5.2 Specifications60
- 5.3 Power Supply Interface61
SLR 5000 Series Front Panel65
- 6.1 Description65
  - 6.1.1 General Description65
- 6.2 Input and Output Connections65
- 6.3 Interfaces66
  - 6.3.1 Modem Interface66
  - 6.3.2 User/Service Interface66
    - 6.3.2.1 USB66
    - 6.3.2.2 LED Indicators66
SLR 5000 Series Back Panel67
- 7.1 Description67
  - 7.1.1 General Description67
- 7.2 Back panel Interfaces68
SLR 5000 Series Test Equipment And Service Aids77
- 8.1 Recommended Test Equipment77
- 8.2 Service Aids77
SLR 5000 Series Performance Check or Testing79
- 9.1 General79
- 9.2 Transmitter Testing79
- 9.3 Receiver Testing81
- 9.4 Auto Test and Tune Support83
SLR 5000 Series Programming and Tuning85
- 10.1 Introduction85
- 10.2 Customer Programming Software Setup85
- 10.3 Reference Oscillator Alignment86
  - 10.3.1 Tuning Procedure86
- 10.4 Repeater Tuning Setup87
- 10.5 Rx Audio Level Set87
  - 10.5.1 Tuning Procedure87
- 10.6 Tx Audio Level Set88
  - 10.6.1 Tuning Procedure88
- 10.7 Modulation Limit Alignment89
- 10.8 Changing to Battery Charger Only Mode92
SLR 5000 Series Maintenance and Disassembly/Reassembly93
- 11.1 Introduction93
- 11.2 Routine Maintenance93
- 11.3 Preventive Maintenance93
  - 11.3.1 Inspection93
  - 11.3.2 Cleaning Procedures93
- 11.4 Safe Handling of CMOS and LDMOS Devices94
- 11.5 Disassembly95
  - 11.5.1 Disassembly – General95
  - 11.5.2 Disassembly – Detailed96
- 11.6 Assembly and Reassembly101
  - 11.6.1 Assembly – Detailed101
- 11.7 Exploded Mechanical View111
- 11.8 Parts List112
- 11.9 Torque Charts113
SLR 5000 Series Installation115
- 12.1 Pre-Installation Considerations115
- 12.2 Mechanical Installation122
  - 12.2.1 Equipment Unpacking and Inspection122
  - 12.2.2 Mounting Procedures122
- 12.3 Electrical Connections124
  - 12.3.1 Power Supply Connections125
- 12.4 Post Installation Checklist127
- 12.5 Installing Repeater Hardware Options127
  - 12.5.1 General Bonding and Grounding Requirements127
  - 12.5.2 General Cabling Requirements128
Appendix A : Accessories129
- Introduction129
Appendix B : Replacement Parts Ordering133
- Replacement Parts Ordering133
Appendix C : Motorola Service Centers135
- Motorola Service Centers135
Appendix D : SLR 5000 Series Third-Party Controllers137
- Overview137
- Community Repeater Panel137
- Phone Patch141
- Tone Remote Adapter144
- Trunking Controllers148
Appendix E : Audio Enhancement153
- Overview153
Appendix F : MOTOTRBO Repeater – EME ASSESSMENT155
- Executive Summary155
- Exposure Prediction Model155
  - Exposure in Front of the Antenna155
  - Exposure at Ground Level157
- Typical System Configuration158
- Exposure Limits158
- EME Exposure Evaluation158
  - Exposure in Front of the Antenna158
  - Exposure at Ground Level159
- Compliance Boundary Description159
- Product Put In Service159
- References160
Glossary of Terms and Acronyms161
- Alert tone161
- Analog161
- ASIC161
- AUX161
- Band161
- CTCSS161
- Clear161
- Conventional161
- CPS161
- Default161
- Digital161
- DPL161
- DSP162
- EIA162
- ESD162
- EU162
- FCC162
- FM162
- Frequency162
- FRU162
- FSK162
- GNSS162
- GPIO162
- IC162
- IF162
- I/O162
- kHz163
- LCD163
- LED163
- MDC163
- MHz163
- MISO163
- MOSI163
- PA163
- PC Board163
- PFC163
- PL163
- Programming Cable163
- PTT163
- Receiver164
- Repeater164
- RF164
- RSSI164
- Rx164
- SCM164
- SELV164
- Signal164
- SINAD164
- SLR164
- Spectrum164
- SPI164
- Squelch164
- TOT165
- TPL165
- Transceiver165
- Transmitter165
- Trunking165
- Tx165
- UHF165
- USB165
- VCO165
- VCTCXO165
- VHF165
- VIP165
- VSWR165
- WLAN165

Motorola Mototrbo - Document History

Table of Contents

Other manuals for Motorola Mototrbo

Related product manuals