Location Connector Type Function(s)
3 Option Dependent Option Dependent 1
4 Option Dependent Option Dependent 2
5 Type A Socket USB
6 RJ-45 – Jack Ethernet 2
7 RJ-45 – Jack Ethernet 1
8 DB25 – Female Aux: Rx Audio, Tx Audio, PTT, COR, Accessory Power, 1 PPS, and
GPIO
9 BNC – Female Receiver RF (Rx)
10 BNC – Female Frequency Reference Input (REF)
11 T30 TORX Screw Bonding Ground Connection
12 N-Type – Female Transmitter RF (Tx)
There is also a USB connection associated with maintenance and troubleshooting of the repeater. This
connection is located on the front of the repeater. See Figure 82: Location of USB Connector on page
125.
Figure 82: Location of USB Connector
Table 43: Callout Legend
Label Description
1 USB Service Port
12.3.1
Power Supply Connections
12.3.1.1
AC Input Power Connection
CAUTION:
Do not apply AC power to the repeater at this time. Make sure that the circuit breaker
associated with the AC outlet is turned OFF.
The AC socket-outlet must be installed near the equipment and must be easily accessible.
Each repeater is shipped with an 2.5 m (8 ft) 3-conductor line cord. See Figure 81: Back Panel
Connector Names and Locations on page 124 for AC power inlet connector. Insert the plug into an
appropriate grounded outlet.
Chapter 12: SLR 5000 Series Installation
Motorola Solutions Confidential
Send Feedback 125
To Next Page
Loading...
