Motorola Mototrbo - CPS Configuration

CPS Configuration
The SLR 5000 Series Repeater will need to be configured via the CPS application as shown in Figure
86: CPS Configuration for Community Repeater Panel (1 of 2) on page 140 and Figure 87: CPS
Configuration for Community Repeater Panel (2 of 2) on page 140. More specifically, the affected
parameters are as follows:
• Audio Type
- Filtered Squelch
• Analog Accessory Emphasis
- De & Pre
• Disable Repeat Path
- Un-Checked
• Tx Audio Priority
- 0
• GPIO Pin number 2, 11
- Ext PTT
- Active Low
• GPIO Pin number 4
- PL/Talkgroup Detect
- Active Low
• Squelch Type (Rx)
- TPL
• Squelch Type (Tx)
- TPL
Figure 90: CPS Configuration for Phone Patch (1 of 2)
Appendix D : SLR 5000 Series Third-Party Controllers
Motorola Solutions Confidential
Send Feedback 143