• PTT
• Monitor
• Channel Select (up to 15 frequencies)
• Wildcard (e.g. Repeater Knockdown)
See Motorola Tone Remote Adapter Manual (supplied with the Tone Remote Adapter) for
specifications, operation, installation, alignment, programming, alternate configurations, and repair
information.
Figure 92: Model L3276 Tone Remote Adapter
Compatibility
Model L3276 Tone Remote Adapter is compatible for all versions of SLR 5000 Series Software and
Hardware.
Hardware Connections
The connections between the SLR 5000 Series Repeater and the Tone Remote Adapter are facilitated
with a multi-conductor cable connected between the J7 SLR 5000 Series back panel AUX 25-Pin
connector and that of the Tone Remote Adapter. The connection provides for the following signals:
• Transmit Audio
• Receiver Audio
• PTT
• COR
• Monitor
• Channel Steering
• Wild Card (E.g. Repeater Knockdown)
• Ground
Signal connections are noted in Figure 85: Signal Connections between SLR 5000 Series Repeater
and Community Repeater Panel on page 139. SLR 5000 Series Repeater connector and physical Pin
locations are noted in the backplane interface board section of this manual. See Motorola L3276
25-Pin manual for its connector and physical Pin locations. The part number for a pre-fabricated cable
is noted in the SLR 5000 Series ordering guide.
Appendix D : SLR 5000 Series Third-Party Controllers
Motorola Solutions Confidential
Send Feedback 145
To Next Page
Loading...
