Motorola Mototrbo - CPS Configuration

Figure 98: Signal connections between SLR 5000 Series Repeater, Trident Model Raider,
Marauder and NTS
Male DB25 Female DB25
Raider and MarauderSLR 5000 Series
White
Black (Paired with White)
Shield from Blk/White Pair
Green
Black (Paired with Green)
Shield from Blk/Green Pair
Red
Black (Paired with Red)
Shield from Blk/Red Pair
Tx Audio
Tx Data
Gnd
Gnd
Gnd
Gnd
Rx Audio
GPI1 (PTT)
13.6VDC
Tx Audio Output
Tx Data Output
Tx PTT Output
Power
Receiver Discriminator Input
3
5
1
20
13
25
22
13
16
7
2
17
20
19
18
Male DB25 Female DB9
Raider and MarauderSLR 5000 Series
White
Black (Paired with White)
Shield from Blk/White Pair
Green
Black (Paired with Green)
Shield from Blk/Green Pair
Red
Black (Paired with Red)
Shield from Blk/Red Pair
Tx Audio
Tx Data
Gnd
Gnd
Gnd
Gnd
Gnd
Gnd
Rx Audio
GPI1 (PTT)
Transmit Audio
Transmit Data
PTT
Discriminator Audio
3
4
1
2
9
5
22
13
16
7
2
17
19
18
CPS Configuration
The SLR 5000 Series will need to be configured via the CPS application as shown in the figures below.
More specifically, the affected parameters are as follows:
•
Audio Type
-
Flat Unsquelched
• Disable Repeat Path
- Checked
• GPIO Pin number 2
- Ext PTT
- Active Low
Appendix D : SLR 5000 Series Third-Party Controllers
Motorola Solutions Confidential
150 Send Feedback