Figure 99: CPS Configuration for Trident Model Raider, Marauder and NTS
Trunking Controller Settings
The input and output levels should be adjusted per the trunking controller’s instructions. The summary
below gives a brief overview of the high level characteristics and trunking controller settings for
configuration with the SLR 5000 Series Repeater.
Discriminator
The SLR 5000 Series Repeater’s Receiver audio will yield 330 mV rms into 50 kΩ with an RF input
signal deviating at 60% RSD. With the trunking controllers own loading impedance, the “Discriminator”
signal delivered to the trunking controller will need to be boosted by setting the following jumpers in the
noted position:
• Marauder and Raider
-
W22: OUT position
- W30: IN position
Tx Audio
The SLR 5000 Series Repeater’s transmitter will yield 60% RSD with 80 mV rms into the Emph Tx
Audio port. No range setting is provided in the trunking controller for the Tx Audio, rather the level is
solely controlled by a singular potentiometer or soft-potentiometer.
Tx Data
The SLR 5000 Series Repeater’s transmitter will yield 60% RSD with 80 mV rms into the Tx Data port.
No range setting is provided in the trunking controller for the Tx Data, rather the level is solely
controlled by a singular potentiometer or soft-potentiometer.
• Marauder, Raider and NTS
- Data needs to be inverted
Appendix D : SLR 5000 Series Third-Party Controllers
Motorola Solutions Confidential
Send Feedback 151
To Next Page
Loading...
