Radio Communications 4 - 27
PIN Code
To set the PIN code (e.g., password) on the device, scan the bar code below followed by five alphanumeric
programming bar codes from Appendix E, Alphanumeric Bar Codes. The default PIN code is 12345.
If the device communicates with a cradle with security enabled, synchronize the PIN codes on the device and
cradle. To achieve this, connect the device to the cradle when setting the PIN codes. If the device is not connected
to a cradle, the PIN code change only takes effect on the device. If security is required between the device and
cradle, and the PIN codes do not match, pairing fails. If the PIN codes are not synchronized, re-synchronize them
by disabling security, establishing a connection to the cradle, and then programming a new PIN code.
Variable PIN Code
The default PIN code is the user-programmed Static PIN Code. For connections requiring a variable PIN code
(commonly HID) scan the Variable PIN Code Mode. Attempt connection again, wait for the prompt to appear on
the display and enter the PIN code using the device keypad. When variable PIN code mode is selected the device
remains in this mode until you change the mode by device set defaults (see Set Default Parameter on page 5-4) or
Static PIN Code Mode.
Set PIN Code
*Static PIN Code Mode
Variable PIN Code Mode
To Next Page
Loading...
