Motorola MT2070 - Scanning Sequence Examples; User Preferences;Miscellaneous Options Parameter Defaults

5 - 2 MT2070/MT2090 User Guide
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code listed under Beeper Tone on page 5-13. The device issues a fast
warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Time-Out or Data Transmission Formats, require scanning several
bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences/Miscellaneous Options Parameter Defaults
Table 5-1 lists defaults for user preferences parameters. Scan the appropriate bar codes in this guide. These new
values replace the standard default values in memory. To recall the default parameter values, scan the Set Default
Parameter on page 5-4.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 5-1 User Preferences Parameter Defaults
Parameter
Parameter
Number
Default Page Number
User Preferences
Set Default Parameter Set Defaults 5-4
Host Mode F1h A4h Cable Priority 5-5
Decode Pager Motor Enable F1h 65h Disable 5-6
Parameter Bar Code Scanning ECh Enable 5-7
Scan Angle BFh Wide 5-8
Adaptive Scanning F1 CD Enable 5-7
Adaptive Scanning
Interference Suppression Mode
F8h 04h B3h Ambient Light Interference
Suppression Auto Detection
5-10
Adaptive Scanning
Interference Suppression Scan Angle
F8h 04h DBh Wide 5-11
Beep After Good Decode 38h Enable 5-12
Beeper Tone 91h Medium 5-13
Beeper Volume 8Ch High 5-14