Motorola MT2070 - Scan-To-IP

2 - 32 MT2070/MT2090 User Guide
Scan-To-IP
The Scan-to-IP screen allows the user to scan directly to a host PC using your existing wireless network. The
application should be pre loaded on the Motorola MT2090 device
.
The host application must be installed on your PC or terminal host.
Setup
• Install the host application on your PC or terminal host. Visit http://www.scan-to-ip.com to download both the
Windows host application and the device installer, if necessary.
• Run the host application, ScanToIp.exe, from the Scan-to-IP folder on the PC or terminal host.
• To access Scan-To-IP, start at the Home screen, scroll to Scan-To-IP and press ENT.
Figure 2-32 Scan-To-IP Option on Home Screen
• Click the Setup tab. Press the right soft key to display the Setup.
Figure 2-33 Scan-To-IP Screen
NOTE Scan-to-IP may not be loaded on older devices. In this case, download the application to your PC;
establish an ActiveSync connection; run ScanToIpDeviceInstaller.exe to download it to the MT2090.