Motorola MTM800 - 26.4.11 DTR Link Down Indication Time; 26.4.12 Store And Forward; 26.4.13 Number of Service Centre; 26.4.14 Traffic Stealing

3-112 Customer Programming Software (CPS)
6866537D87-F Chapter 3 - MTM800 Product Information Manual September 2008
26.4.11 DTR Link Down Indication Time
When the terminal is in data mode, this is the time after which it will indicate, to the user, that the
down link has been lost.
The range of this timer is 0 to 255 seconds.
26.4.12 Store And Forward
Activates / deactivates the storing in the Message Service Center and forwarding of the subscriber's
outgoing messages.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
26.4.13 Number of Service Centre
Enter the number (address) of the Message Service Centre that will be responsible for storing and
forwarding the subscriber's outgoing messages.
26.4.14 Traffic Stealing
This is always associated with a traffic channel.
If enabled, the terminal will ‘steal’ part of a traffic channel’s signalling capacity to pass the data as
and when required.
26.4.15 Default Validity Period
This field defines how long the outgoing message will be held by the message service centre in the
event that the message cannot be delivered to the destination (a destination handset may be
unavailable due to being out of coverage or switched off). To choose the period, place the pointer
into the field value, click on the arrow, and drag the pointer to the desired period. Selecting “No
validity” means that the Message Service Centre will not hold the undelivered message.
26.4.16 Group Call Notification While Composing SDS
Indicates if incoming group call display should be posted to user while composing SDS. If this field
is disabled, the group call will only be heard without display notification.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
26.4.17 Status During Group Call
Defines option for sending a status during active group or broadcast call.
The options are:
•Not Allowed - Not allowed to send Status while there is an active group call.
• Leave Call to send Status - The call will be disconnected and the Status will be sent.