Motorola MTM800E - Page 191

183
What to do if...
Codeplug
setting Error:
CH Role
Selection
CH is powering
OFF
The message is displayed when the control head
configured as Slave is connected to the Transceiver and
the control head configured as Master is connected as
standalone (i.e. not to the Transceiver).
Standalone
Mode
Radio is
powered OFF
No available
services
The message is displayed on Slave Control Head in
Standalone mode.
Software Error:
Incompatible
SW ver.
No available
services
The message is displayed on Slave Control Head only
when the software version is different than on Master.
Dual CH Link
Error!
Verify cables
connection
The message is displayed when the connection
between Control Heads is lost.
WAP initiated
Not available on
this unit
End to abort the
operation
The message is displayed on Slave when the Master
Control Head is using WAP.
Messages Message Description