Starting the CPS Application 3-7
March 2009 Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual 6866588D21-D
number of features receives the Feature Enable kit, that is the Customer CPS and an USB dongle
("Feature Enable Dongle") that contains information about the total number of enables per feature.
Feature enabling can be performed on one or more terminals simultaneously – all in one operation.
Proceed as follows:
1. Connect the terminal to the PC as described in the terminal’s hardware set-up. The terminal’s
codeplug contains special block for keeping the list of feature paid flags, each of which corre-
sponds to a separately paid feature.
2. Connect the Feature Enable dongle to the PC.
3. Run the CPS.
4. Enter the Administrator password.
5. Note: Do not read the terminal now!
Select Tools/Enable Feature. The Enable Feature dialogue opens up and displays
information related to the dongle and the terminal attached to the currently active port.
6. Enable the check box next to the feature you have paid.
7. Click Burn. Each counter will be decreased each time you enable one of the features you
have ordered.
8. The CPS scans communication ports and detects the terminal that is connected to the port.
The Operation Results message appears and displays the result of operations per each port.
Click Continue button.
9. The CPS will display the operation result for each terminal.
Note: If all paid features are enabled in a dongle and several terminals are connected for simulta-
neous feature enabling. Some features may not have been paid for some of the terminals or may
already have been enabled. The Customer CPS will automatically detect which features were paid
or enabled for each terminal and will not decrease the counter.
To Next Page
Loading...
